dane wrote: ↑Tue Dec 19, 2023 4:46 pm
I don't think IPv6 tunnel setup would be applicable, now that IPv6 is rolled out all across the fiber network.
But yes, we can't support non-Sonic equipment, that'd be a DIY project.
Hello Dane, I totally understand that there is no official support for DIY stuff and I am sorry if my question came across as "fix my Meraki", but from the traffic I am seeing it appears that the DHCP response from Sonic is saying that no Prefixes are assigned to my network.
I see the Router Advertisement setting a Juniper device as my next hop and the flag set to use DHCPv6 to get the remaining information. I see the first IA_NA conversation that sets my Meraki's IPv6 Address and DNS, but when my Meraki sends the IA_PD request to the network, the responce I get is "Status Code 13 / Status Code: NoPrefixAvail (6) / Status Message: No prefixes have been assigned".
I know I had an issue with my account a little while ago where too many MAC Addresses were sent to Sonic, and I do not know if this could be related where the Sonic network got too many requests from my network and accidently reserved my /56. Is there a way someone can check my IPv6 configuration and maybe clear whatever assignements might be in place?