can't change ipv6 tunnel endpoint to FTTN ip

[toast0]

I just got my FTTN setup (line stats in another post), and I was hoping to change my legacy IPv6 tunnel endpoint to the IPv4 address from FTTN (99.189.168.247). But when I try, I get an error: Failed to change endpoint.

(I'm aware there's a good chance this won't work anyway, because the CPE may not pass the tunneled traffic)

[kgc]

Fusion FTTN service has v6 enabled out of the box using 6rd through AT&T's network. Endpoints off our network aren't supported for legacy v6 tunnels- this includes Fusion FTTN endpoints.

[toast0]

Thanks for the quick reply. I didn't realize the legacy tunnels were restricted to Sonic's network; that makes sense.

[kgc]

I'll put a note in the tool that makes this limitation clear.