Connecting and Port Forwarding a Synology NAS to the Smartrg sr515ac

General discussions and other topics.
2 posts Page 1 of 1
by tobinjones72 » Tue Jun 12, 2018 11:04 pm
I connected the Synology to LAN 1. All lights are on. I have Sonic Fiber service, wifi
etc is working.
These were the instructions I followed but no success yet.

Go into Advanced Setup->LAN. Under the " Static IP Lease List" section click add entries, and
enter the MAC address for your NAS and pick an IP within the range for it.

To enable port forwarding to that IP inside your netowork go into Advanced Setup->NAT and click add. Enter the external/internal port values and correct protocol(s).. There may be multiple ports that your NAS operates over so you need one entry per port (each entry specifies the port number four times).

by ngufra » Wed Jun 13, 2018 9:17 am
Did not see the question.
Is it not working? What is not working?

What are you trying to do? are you trying to access your synology at home from the internet?
Are you using some dynamic dns to resolve your home IP?
Does it work from home?

Which services are you trying to enable and which ports did you enable forwarding ?
2 posts Page 1 of 1

Who is online

In total there are 2 users online :: 0 registered, 0 hidden and 2 guests (based on users active over the past 5 minutes)
Most users ever online was 422 on Sat May 26, 2012 5:28 am

Users browsing this forum: No registered users and 2 guests