Replacing phone service with Sonic (pots, wiring, jacks)

Fusion Voice service, features and help.
5 posts Page 1 of 1
by cgthayer » Mon Sep 24, 2018 2:24 pm
I have regular pots phone service in my house reaching 4 jacks, and I have sonic fiber. I'd like to attach the RG's single phone jack to my system. Other than disconnecting the old service and wires, is there anything I should know about attaching the Sonic phone service to my existing jacks?
by dane » Mon Sep 24, 2018 2:57 pm
Nope, it's pretty easy. Just unplug or un-wire the prior POTS service at the MPOE or wiring location, and feed that from the Sonic optical network terminal's RJ11 voice output.
Dane Jasper
CEO
Sonic
by danielg4 » Tue Sep 25, 2018 4:38 pm
Just bear in mind that the Adtran 411 ONT is rated for a maximum REN of 3.0, whereas 5.0 is the standard maximum REN for POTS.
by tquiggle » Tue Jan 08, 2019 1:29 pm
dane wrote:
Nope, it's pretty easy. Just unplug or un-wire the prior POTS service at the MPOE or wiring location, and feed that from the Sonic optical network terminal's RJ11 voice output.


If I can just plug my existing POTS phone into the Adtran 411's RJ11 port, why does Fusion Fiber require a $6.50/month ATA rental?

Tom
by danielg4 » Wed Jan 09, 2019 2:53 pm
There is no ATA rental with the Sonic Gigabit Fiber service. The ATA rental is only for service over AT&T's transport, which does not use the Adtran 411.
5 posts Page 1 of 1

Who is online

In total there are 4 users online :: 0 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 422 on Sat May 26, 2012 5:28 am

Users browsing this forum: No registered users and 4 guests