Currently under the Labs-->IPv6 Tunnels within the Member Tools section there are only 2 options available when selecting the "View/Request Tunnel" bar and going into the next menu screen after an entry of the IPv4 tunnel endpoint, which are:
View/Request/Change Tunnel
View Example Configuration
However, there is NO option available to fully clear out the configuration after selecting the "View/Request Tunnel" menu option bar on the prior page once an IPv4 tunnel endpoint entry on the current configuration page is made. There needs to be a 3rd option on the IPv6 Tunnels configuration page that allows clearing out this configuration as if it was not performed in the first place or for it to go offline or inactive. The 3rd available option on this configuration page could be as follows instead of the above:
View/Request/Change Tunnel
View Example Configuration
Remove Tunnel/Change to Offline
Thank you
View/Request/Change Tunnel
View Example Configuration
However, there is NO option available to fully clear out the configuration after selecting the "View/Request Tunnel" menu option bar on the prior page once an IPv4 tunnel endpoint entry on the current configuration page is made. There needs to be a 3rd option on the IPv6 Tunnels configuration page that allows clearing out this configuration as if it was not performed in the first place or for it to go offline or inactive. The 3rd available option on this configuration page could be as follows instead of the above:
View/Request/Change Tunnel
View Example Configuration
Remove Tunnel/Change to Offline
Thank you