New Fiber Install issues

Internet access discussion, including Fusion, IP Broadband, and Gigabit Fiber!
2 posts Page 1 of 1
by juanparker101 » Tue Oct 16, 2018 10:33 pm
I have just had the ATT fiber service installed in my place. So far so good, but I have a pretty extensive Ubiquiti network setup and want to continue using it this new service. Problem is after following these instructions https://forums.att.com/t5/AT-T-Internet ... -p/5296974

It will not pass along the IP address to my USG.... I attempted to call Sonic support but they pretty much told me that it should just work. I should just plug in the router to the ATT router and everything should work fine. Thats not the case though. I am kinda at a loss as what to do next. I am considering canceling the service if this cannot work. Is there another more advanced Sonic support tier I can contact?
by timyu94 » Tue Oct 16, 2018 10:53 pm
https://community.ubnt.com/t5/EdgeRoute ... -p/2253363

Third or fourth post down has someone with a similar sounding issue that they resolved.

I have no issues doing IP passthrough on the 210-700 to my Pfsense router so make sure you follow the IP passthrough guides (past NVg 589/599 guides also help).
2 posts Page 1 of 1

Who is online

In total there are 32 users online :: 2 registered, 0 hidden and 30 guests (based on users active over the past 5 minutes)
Most users ever online was 999 on Mon May 10, 2021 1:02 am

Users browsing this forum: amayfield, jacob.karinen and 30 guests