I have a Pace 5268AC Residential Gateway and I have an issue with trying to setup application pinholes (port forwarding) by IP Address rather than by device. When I have a physically connected device that shows up in the registered device list on the residential gateway, then port forwarding works properly. However, when I try the same port forwarding config by manually entering the IP address, then it does not work.
I need to setup port forwarding by IP address rather then the physical device because I have an HA cluster NAS box setup for my mail server and I want the port forwarding to work using the HA cluster virtual IP address rather than the physical device IP addresses so that HA failover can happen and the port forwarding configuration should still operate fine with the cluster virtual IP address.
Please help me setup the Pace RG properly for port forwarding with the virtual cluster IP.
I need to setup port forwarding by IP address rather then the physical device because I have an HA cluster NAS box setup for my mail server and I want the port forwarding to work using the HA cluster virtual IP address rather than the physical device IP addresses so that HA failover can happen and the port forwarding configuration should still operate fine with the cluster virtual IP address.
Please help me setup the Pace RG properly for port forwarding with the virtual cluster IP.