3 phone plugs and 1 dsl/voice splitters in my modem box

Internet access discussion, including Fusion, IP Broadband, and Gigabit Fiber!
3 posts Page 1 of 1
by wimcoekaerts » Wed Sep 14, 2011 11:50 pm
Hi - just signed up and anxiously awaiting my connecting setup next monday for 2 line fusion.

I have a question tho preparing for it : I just received my modem today and the box contained 4 of those beige/brown plugs. 3 of them for a phone/voice (so single rj45) and 1 of them a dual voice/dsl splitter. shouldn't that be 2 of each instead of 3 / 1 ?

I still have my dsl splitter voice/dsl from my almost finished att dsl, I guess that one would also work for adsl2+ ? if so then I guess it doesn't matter but I am still curious if my box should have had 2 of each instead of 3 and 1 :)

looking forward to it.

Wim
by wimcoekaerts » Thu Sep 15, 2011 12:11 am
ah never mind - I guess the single splitter can split both pairs in the single plug.
by jleake » Thu Sep 15, 2011 11:40 am
Yep, that's right.

As a side note, be careful about using the old splitters from your AT&T service. They may not be ADSL2+ and they may not be the dual line filters you need to make sure both lines are properly filtered.
Juliana L.
Customer Support, Sonic.net, Inc.
3 posts Page 1 of 1

Who is online

In total there are 8 users online :: 0 registered, 0 hidden and 8 guests (based on users active over the past 5 minutes)
Most users ever online was 487 on Tue May 05, 2020 2:07 pm

Users browsing this forum: No registered users and 8 guests