Page 1 of 1

IPV6 on my Fusion x2 service

Posted: Sun Dec 20, 2020 8:49 pm
by croaker
Opened a ticket (6222253 ),and was asked to post here.

When attempting to use the Fusion IPv6 Tool, I always get the message that a supported managed IPv6 capable modem associated with this service address.

Tech asked me to post here:

"I looked over our documentation, and checked your modem. The location for setting this up on your modem does seem different, and is missing the fields to setup IPv6. Can you post this on our forums at https://forums.sonic.net/ , as the folks who support the IPv6 functionally read and reply there."

Re: IPV6 on my Fusion x2 service

Posted: Tue Jan 05, 2021 9:54 pm
by croaker
Anyone?

Re: IPV6 on my Fusion x2 service

Posted: Wed Jan 06, 2021 11:59 am
by parker_day
What modem do you use with you Fusion x2 service? I believe the IPV6 tool only supports Sonic provided Pace 5168N, 5268AC, and maybe the SR515AC. Can't remember for sure.

Re: IPV6 on my Fusion x2 service

Posted: Wed Jan 06, 2021 12:36 pm
by jerrielm
Hello!

For the Pace 5268AC, you will need the 10.5.4.527153 firmware version and using Fusion DSL. Sadly it does not seem that your router has that firmware. We are unable to change your firmware to this version. I am sorry for any incovience this may cause you.

Best Wishes!

Re: IPV6 on my Fusion x2 service

Posted: Wed Jan 06, 2021 4:55 pm
by croaker
So what's my recourse here then guys? Sorry, no IPV6 for you?

This is a relatively new device that I'm renting from Sonic after I upgraded to the x2 service.

Re: IPV6 on my Fusion x2 service

Posted: Fri Jan 08, 2021 10:38 am
by jacob.karinen
We're currently looking into it. Sorry I don't have a good answer just yet but I want to let you know that we're reviewing how we can get you new firmware and I hope to have an answer for you soon.

Best regards,