not getting Giagbit speeds on Fiber service

Internet access discussion, including Fusion, IP Broadband, and Gigabit Fiber!
13 posts Page 2 of 2
by ngufra » Fri Oct 09, 2020 9:26 am
so it was a defective wire/jack/socket?

Cat5/6 has 8 wires (4 twisted pairs) 10BaseT and 100BaseT uses only 2 pairs while 1000BaseT uses all four pairs so if you have one of the wires used only for Gbps failing, it would fallback to 100BaseT.
You can get some fairly inexpensive cable testers that check each of the 8 wires (comes in two parts: one that sends across each of the wires in turn, and the other that lights a led for each wire in turn, it allows you to make sure each wire is on and in the right place.
by maranha » Fri Oct 16, 2020 12:36 am
Thanks. I should get one of those testers as its easy to have a flaky wire with DIY wiring.
by dane » Mon Oct 19, 2020 11:40 am
maranha wrote:
Success! After tweaking the RJ45 plug at the switch end I'm now consistently getting over 800Mbps on my cat5e wired connection: ~50' of wire from the router to a gigabit switch + another ~25' of wire from the switch to a wall jack + ~6' of patch cord from wall jack to computer.


Yay, glad to hear you found the source of the trouble!

I didn't suspect Ethernet cable issues because you reported more than 100Mbps speeds. Generally, a cable will either do Gigabit, or 100Mbps (100-Base-T). So when I hear folks reporting 90Mbps-100Mbps speed tests consistently, I think they've got a bad Ethernet cable.

Another category of slow-down is Ethernet dongles that connect via USB. I've seen those performing at 200-400Mbps, and everyone is confused because it's hard-wired Ethernet, right? But the USB (2.0 maybe) won't go that fast.

But I'd say that PC/browser and particularly antivirus software slow-downs are the most common sources of degraded performance for wired systems. These can often be isolated by testing with another system, disabling the antivirus, etc.

And of course, WiFi won't go full Gigabit, yet - and getting folks up to speed on the limitations of WiFi is another challenge for us. WiFi performance will range from 300Mbps to 600Mbps generally, depending upon the client device and access point. How fast the WiFi goes will vary by client, old ones might only do WiFi-4, or 802.11N, and see far slower speeds. Some might not support 5Ghz, or not be configured to use it. And clients with 1x1 antennas will be slower than 2x2 antennas. But finding all these specifications can be a challenge.

But the good news: Unless we've got an equipment issue, the fiber just does gigabit. The source of slowdown can almost always be isolated in the local area network. And that's great, because now your ISP isn't the issue, it's a local one that can be resolved. Maybe it requires that a 100Mbps switch be replaced with a gigabit one, or that a client device be upgraded or replaced. But your internet connection is gigabit, and you can make changes if necessary on your side to access that full capacity.
Dane Jasper
Sonic
13 posts Page 2 of 2

Who is online

In total there are 20 users online :: 1 registered, 0 hidden and 19 guests (based on users active over the past 5 minutes)
Most users ever online was 964 on Tue Sep 29, 2020 11:23 pm

Users browsing this forum: Bing [Bot] and 19 guests