I'm wondering how any firewall/NAT rules can be disabled in the provided internet gateway so that only the firewall/NAT configurations on my router are in effect. I don't want to constantly have to configure these settings in separate places.
Configuration steps to perform on the BGW210-700:
1. Login to the BGW210-700's web-based configuration interface in your web browser using the link: https://192.168.1.254
2. Go to the "Home Network" tab -> "Wi-Fi" tab
3. Set Home SSID Enable to "Off"
4. Set Guest SSID Enable to "Off"
5. Set 2.4 GHz Wi-Fi operation to "Off"
6. Set 5 GHz Wi-Fi operation to "Off"
7. Go to the "Firewall" -> "Packet Filter" tab. Click on the "Disable Packet Filters" button.
8. Go to the "Firewall" -> "IP Passthrough" tab. Select "Passthrough" in the "Allocation Mode" option
9. Do not enter anything for the "Default Server Internal Address". Leave this field blank
10. In the "Passthrough Mode" selection choose "DHCPS-Fixed".
11. Type in the LAN MAC address for your personal router under "Manual Entry". The MAC address should be in traditional hexadecimal format xx:xx:xx:xx:xx:xx where x's should be values from 0-9 or letters a-f, separated by colons.
12. The Passgthrough DHCP Lease value defaults to 10 minutes. You cannot change this.
13. Click "Save" at the bottom. Go back and check to make sure that the changes were implemented. If not, do it again.
14. Click on the "Device" tab and select "Restart Device". It will take a couple of minutes.